 |
|
| |
 |
Wuxi high-tech ultra thin stone material Co.,Ltd.
Address:
No.9, Jinghua road, Industrial park,Xibei Town, Xishan district, Wuxi
Tel: 86-510-83922668
Fax: 86-510-83922778
Contact: Mr Du
Mobile phone: 86-18115395629
QQ:905979741
Zip code: 214194
Email: 905979741@QQ.com |
|
| |
|
|
|
- News and information
|
| |
| What are the installation methods of stone aluminum honeycomb plate? | | Update time: 2022/6/10 17:02:39 Clicks: 657 |
| | Installation method of stone aluminum honeycomb plate:
1. Lifting lug type: the installation method is to separate the lifting lug from the honeycomb plate. After the lifting lug is treated separately, the bonding part is connected with the honeycomb plate, and the appropriate width of the bonding part is ≥ 12mm. The installation method makes the processing simple and the installation convenient. 2. Flanging type: the installation method is to process the aluminum honeycomb plate, that is, to process the installation flange. The installation only needs to be connected with the keel and glue. The width of glue joint should be about 10mm. This method is simple to install, but the process is a little complicated, so it is not suitable for the modeling of curtain wall panels. 3. Buckle type: the node is aluminum buckle, which is easy to install after deducting the specific configuration file. However, this method requires high machining accuracy for metal plates and is not recommended for plates with a length of more than 3000 mm. Specific construction steps for stone honeycomb panels such as buckle width, 20 mm and 40 mm plate stitching: 1. The stone shutter shall be perpendicular to the keel positioning and release line. The keel installation elevation deviation shall not be greater than 3mm, the axial front back deviation shall not be greater than 2mm, and the left-right deviation shall not be greater than 3mm. 2. The vertical steel keel is welded with the steel structure, the weld height is 6mm, there is no false welding and slag inclusion, and the undercut is less than 0.5mm. 3. The angle steel and vertical keel are connected by stainless steel bolts. Spring washers are used for relaxation. Adjust the position of the angle code. The front and back deviation of the axis shall not be greater than 1mm. Tighten the bolts after adjustment. 4. The aluminum alloy beam is connected with the corner code by stainless steel bolts, and the spring washer is loose. The beam shall be horizontal, and the horizontal elevation deviation of two adjacent beams shall not be greater than 1mm. Elevation deviation on the same floor: not more than 5mm when the curtain wall width is less than or equal to 35m, and not more than 7mm when the curtain wall width is greater than 35m. | Total:1 pages page: 1  |
| | Previous：Selection requirements of stone aluminum honeycomb panel Next：What are the characteristics of stone honeycomb board? |
|
|
